Box for the oil bottles laying on the table

Few words

I always have a couple of bottles standing near to the stove and don't want oil to drop on the table. And the pepper grinder is also a source of small particles dropping from the bottom. So I decided to make a box capable of holding a couple of kg which is easy to carry and looks like my knife block. I don't like printed in one piece designs and don't trust layers adhesion, so here is a split design.

I included a f3d source file for it, so if you want to adjust  anything you can. Or I can make the box smaller and printable on a smaller printer (if there is any interest).

Materials

I used eSun petg-cf (black) and eSun petg-hs (orange). CF is only 8%, so it doesn't give much stiffness compared to the regular petg. Printed 0.2mm, 10% infill 4 walls. All parts outside on the table. I use a PEI sheet, so this way they look better and more solid (compared to the top level).

I used heat set inserts M3 L4 OD5 - 10pc. Bottom holds quite well itselfs, but to make sure the front and back walls won't become wonky I used small M3*6 shcs - 2pc. And M3*6 -8pc shcs to hold side panels. That is literally it.