BTT Manta M5P Slim Dual 4010 Blower Fan

BE SURE TO HAVE ENOUGH FRESH AIRFLOW TO THE BLOWERS OR A WAY FOR THE HOT AIR TO SCAPE AFTER IT HIT THE DRIVERS, THEY WOULD OVERHEAT IF ENCASED WITH THE BLOWERS ONLY.

---------------------------------------------------------------------------------------------------

Small and Slim contraption to fit 2x 4010 blower fans on to a BTT Manta M5P to cool the stepper drivers. 

24v fans recommended, 12v doesn't seem to generate enough airflow for high speed printing. Use supports at the bottom and remove carefully. Printed in prusament PETG, PLA may deform depending on how hot the electronics get.

Added a stepper driver heatsink to the main board MCU since the fans are in top of it, so far seems to have good performance in a very slim factor which is what I needed.

Using 4 M3x12 to screw the fans from below and depending on your mount you will need 3 M3 larger screws to mount the adapter.