Sanwa Snap-in Arcade Button Remover (30mm & 24mm)

A simple tool for quickly removing Sanwa Snap-in Arcade Buttons
1
4
1
22
updated February 5, 2025

Description

PDF

Introduction


Simple stuff.  Push it flush with the panel to push the snap-in clips, and you can use a finger to push the button out.  I made one in both 30mm and 24mm.  Makes my life just a little easier.

Works for Sanwas--can't confirm with other button types.

Printing Suggestions

  • 3 Walls / 100% infill / No supports
  • Only tested in PLA, but any material will be fine
  • Print with the thicker side facing the build plate
  • Enable polyholes in Slicer if available to ensure the diameter of the inner circle doesn’t shrink too much. Not required, but could make a difference. 

Tags



Model origin

The author marked this model as their own original creation.

License