2 pair Sunglasses holder for Skadis. Credit for mounting system to @LayerCake.

I needed some sunglasses shelves for my girlfriend, so I ran this up in Fusion. Holds two sunglasses securely with no worry about them falling off or getting bumped off the holder. The corners have 0.4mm anti-lift tabs modeled in. They cut off cleanly and easily when the print is complete. Supports are minimal and should be set to bed only for the cavity on the back of the sunglasses mount. Use support blocks to keep the slicer from putting supports under the retention plate as they aren't needed.

The mounting system used is from @LayerCake and is the best mounting system I've found for any Skadis creations.