Sunton 7inch Display Housing (ESP32-8048S070) with Stand

The original design is great, but I wanted some enhancements. Because the STL showed some faults after importing into CAD, I decided to re-draw the whole model.

On the Frontframe, the mounting holes for the Sunton display got M3 thread-inserts.

Two reinforcers were built into the Backcover. If the stand is to be used, the backcover will also be equipped with two thread-inserts.

For the inserts I used Ruthex M3S (d=3,9/4,6mm l=4,0mm). The front, display and back are fastened to each other by 4x M3x8, for the stand I used 2x M3x5. There will be a little gap between front and back; its intentionally to get a little airflow - if it bothers you: I put by FreeCAD-drawing into this project, feel free to modify it.

The model was printed of Eryone PLA+ black with 0,2mm LH and a 0,4mm nozzle.

If you want more grip, you can put 2 self-adhesive pads under the stand and 2 pads under the frame.

Completely new drawn model with heat-mounting tread-inserts and a stand to put the display on a table.