Modern rounded slippers wall holder

Modern and simple slippers holder for your room. It can be mounted with screws or double-sided tape. The design is straight forward and is easy to assemble. Your starter size can be printed with less than 60g, which is more than enough to hold up to size 42 (EU) slippers. 

Before proceeding, please do check my profile for other shoe racks and other aesthetic models. Some models are only posted on MakerWorld due to exclusive rights, you may check it out on MakerWorld @Levanter 

It consists of 4 parts. 

• Base
• Holder, can be mounted with screws, or taped with 3M double-sided tape.
• Side 1
• Side 2

Setup

• Select the print profile and print your parts. 
• Mount the holder with either screws or 3m double-sided tape.
• Mount the sides onto the base.
• Mount the base onto the holder.

Sizes: 

• Size 0: 68mm between the sides, 14.5mm between the base and the side.
• Size 1: 85mm between the sides, 18.125mm between the base and the side.
• Size 2: 127mm between the sides, 27.1875mm between the base and the side.

Size 1 is 25% scale, Size 2 is 50% scale of Size 0. Because there's no way to provide this in a proper generic print profile, please slice it in your desired slicer. 

Use 12% infill with gyroid structure for your print, at 0.2mm layer height and 0.4mm nozzle. 

The holder has a tolerance of 0.25mm, which is proper for an easy replacement. Please, print it in PETG for best performance. Using any PLA matte filaments will yield a lovely finish but weaker result. It's okayish to use PLA matte as long as you're hooking hulk shoes :)