Filament Spool Holder

spool holder filament printed with minimal filament consumption.

holder suitable for IKEA SAMLA box 39x28x28 cm / 22 l The box can then hold 4 spool filaments.
can be used separately and the number of spool filaments depends only on the length of the aluminum tubes.
The holder is suitable from a spool diameter of 12 cm / 4.72 in and a filament spool side wall width of max 5.5 mm

Slide the individual parts on top of each other and freely change the width of the holder according to the filament spool.
When using a longer aluminum rod, you will use the end piece as a support.

To use the holder in the SAMLA box, you need 2 pieces of aluminum bars with a diameter of 8 mm. length of aluminum bar is 30cm / 11.81 in.

If the holder is in the SAMLA box, a 1L silica gel will fit into the box so that it does not interfere with the filament. 

non-printed parts:

• ball bearing 608 2RS oder 608 ZZ

https://www.aliexpress.com/item/4000029942618.html

or in your hardware store.

• aluminum rod diameter 8mm

You can buy aluminum bars at your hardware store. Better to buy full.

• SAMLA Box, transparent39x28x28 cm / 22 l Article number 801.029.76

https://www.ikea.com/cz/en/p/samla-box-transparent-80102976/