Dan Pistol CAD Metric Version

A Metric and reduced hardware version of the DAN pistol. uses 3d printed bars. Most parts are interchangeable with the original DAN pistol. This blaster prefers darts with sturdy hard foam

The reduced hardware plunger is only compatible with the included metric muzzle( The plunger is inspired by the Gecko plunger + dimensions used from the Rush). Use Gecko print recommendations

If you are Canadian feel free to use both Metric and imperial hardware by combining files from this remix and the original.

BOM required

m3x10 →1
m3x25 →4 
m3x35 →3
m3x40 →3

m4x6 →2

Plunger Tube  35mm id x 38mm od x 77mm long (compatable with 1-1/2" OD, 1-3/8" ID plunger tubes)

Barrel 13mm id x 16mm od → minimum length 230mm(200mm for barrel+ 30mm length as a spring guide)

m3 heat set inserts (5mm od) →15

m3 nut → 2 (they are used on the back grip. they are optional, but recommended)

-012 O-ring →2 (12x1.5mm O-ring also compatible) (I recommend using some glue to hold the o-ring in place on the simple ram)
-123 O-ring →2 (35x2.5mm O-ring also compatible)

Uses original pins(Metric alternative sizes are below)
5mmx40mm pin →2
1.6x25mm → 2
2.4x20mm →3

Catch spring x4

Printed Bars and plastic standoffs are also included with the files

Uses heat set inserts, metric hardware, and reduced hardware. All Parts are interchangeable with original Dan pistol.(except the low hardware plunger that is only compatible with the metric muzzle)