HeunsinkVeld Pedalplate Mounting Hole Template

My Simetik K2 pedal mounting plate does not have any holes to adapt the latest revision of the Heunsinkveld Sprint Pedal Plate (Old revision is 104mm hole spacing while latest revision is 110mm).  So I decide to make a hole template in order to drill only once and have the position of the holes accurate and center based on the Simetik Plate. I used the same M6 bolts that the Heunsinkveld came with to hole the template in my first two holes and drill the rest of then. 

If you are making you own custom pedal plate or are adapting a other one that does not have the proper hole patterns. this will be a good initial start guide to know approximate where the holes will be locate and the final position of the pedals will be.


NOTE: First picture show two different templates, the one cut was made because of the P1S AMS Cutter space taking the needed spacing to print the hole.  so I made the half cut, printed and made the available holes.  I flipped the template and fix everything again in order to make the last hole. if you prefer this template, I can always add it.