Facetron lap screw cover

A replacement cover for the lap screw. Mine became gummy so I made a replacement cover for it. Printed in TPU.  Cut the old one off and push this one on. If needed it can be warmed a bit with a hair dryer but should go on with a little persuasion.

Made 2 versions one flat topped and one with rounded edges . It was 46 degrees in the shop so the print is not perfect. But will do so I'm keeping it.

Printed what will be the top at 1.2mm sides and bottom at 0.8mm with 15% infill

Note, I have been told if you print this with 95A filament you need to put a little glue inside  otherwise it slips a little. They said if you squeezed down it still worked but adding a small amount of glue to the inside of the cover fixes it.  I used 75A filament and did not notice that.