Cable Entry Cap for Nevermore Stealthmax using Micro-fit 3

This is a replacement Cable Entry Cap for the Nevermore Stealthmax air filter. The original cap does not fit a microfit3, at least not when comparing it to the Molex specifications: the slot for the locking tooth is too narrow. This fits. This is also shorter, so it is possible to push in the connector housing using simple pliers. The “panel” is thicker and within Molex specs, which should make the housing sit tight. The retainer bumps on the side are smaller, which makes it possible to tap this in without filing them down.  The panel cutout dimensions are directly from Molex specs, except that the space for the panel locking arms is a tad larger. It is possible to remove the connector by squeezing the locking arms with pliers.

The connector is a three-pin version. 

Modified version of the original Nevermore Stealthmax for use with Micro-fit 3. Thicker panel (1.8mm), wider slot for the microfit3 locking tooth, shorter length to make it possible to push the microfit in the slot, smaller retained teeth on the side (goes in with a tap), panel cut-out per Molex dimensions, except more room for panel locking arms.