HP Omen Obelisk 8509 rear IO Shield

I had bought a motherboard, but didn't think to check if it came with the IO shield or not, so for a bit, i had a computer with a big opening on the back. The PC itself is a bit of a Frankenstein build, with various OEM parts iv either bought for really cheap or free. 

All cutouts and lettering was done in Tinkercad.

Picture of panel itself is the prototype.

I used Geerlingguy's blank as a template, and measured positions and sizes of the ports on motherboard, and made the cutouts. After making a prototype and test fitting, only had to make a couple of tiny adjustments. My original measurements were still to a point where all ports were accessible, but some were a tiny bit off centered.