ViFly Mount and TPU Button for SpeedyBee Mario5 Frame

This is a housing to hold the ViFly Beacon on the Mario5 Frame. It uses a TPU Button to press the button on the ViFly Beacon from the bottom of the frame.

I have only tested this with an HD Zero Camera.  Other systems/cameras may not fit.

I printed the housing from PETG CF, but I think any rigid filament would work (TPU might be too flexible for the housing). The housing should be protected from any impact, as it is well inside the protection of the frame itself.

(2) M2 screws are required to mount the housing, and you may want to use some ShoeGoo or other flexible adhesive to help hold the ViFly beacon in the housing, if the friction fit is not sufficient.

Use the included drill jig to drill a 6.35mm hole in the frame (the jig locates the drill bit in the correct location