MK4S Display Cover with Grip

a Cover for the MK4S that is also thicker than the original to block much more light (epecially e.g. at night)

Print with 8 bottom solid layers! Unless you want to see your infill pattern through the cover

Also, in Expert mode under Filaments→Cooling→Cooling Thresholds, set :

• Enable fan if layer time is below : 25s
• Slow down is layer time is below: 20s
• Min print speed: 5mm/s

These settings are needed for the thin little “legs” to print nicely

Altered to clear the bed at maximum extension,

Added more thickness to the model to block the light better