Dresser Drawer Slide

This is a replacement that I modeled to repair my dresser that has been in my possession for 45 years. The original was stapled in place even though it had holes for screws, of which I used to install the replacement. You can see in the picture that the original had one side broken off. Been like that for many years. 

Finally got around to modeling it. Modeled in Sketchup 7.

Printed in PLA, but PETG would be a good candidate and offer better lubricity.

Best printed solid.

Also polishing the edges that come in contact with a wood T is good to preserve that component.