Voron Trident Skirt - Wago Mounts/Ribbon Cable Passthrough

The Wago terminals allow for an umbilical setup to be quickly connected/disconnected for maintenance or cable routing.

The ribbon cable passthrough is sized for a standard Raspberry Pi camera or display ribbon cable. Check out my Raspberry Pi mount here for more information on how that system works on my Trident! NOTE: Ensure overhangs are well-tuned on your printer for this version. If in doubt, keep a close eye around z-height 4.75mm when bulk of the bridging will occur.

Both features are optional. Match your printer size to the numbers in the .stl filename, then look for the ‘_wago’, ‘_ribbon’, or ‘_wago_ribbon’ at the end of the filename to select the correct option for your use-case. Enjoy!

Remixed the Voron Trident rear center skirt to mount 5 Wago terminals in the same manner as 3DeezNutz did for the Voron 2.4 skirts. I added a ribbon cable passthrough for my Raspberry Pi camera which is mounted on the rear gantry extrusion and sends the ribbon cable down the back center vertical extrusion.