Replacement nose pad for Bollé Rogue tactical goggles

Replacement nose pad for discontinued model of tactical goggles, cannot be bought anymore.
3
7
0
51
updated February 16, 2025

Description

PDF

Replacement nose pad for discontinued model of tactical goggles, cannot be bought anymore (even the manufacturer doesn't produce replacement parts)

  • Printed from TPU on low speed, with ultra high quality settings
  • If you need both left and right, just mirror the model in the slicer along the X axis.
  • When printing both, I highly recommend to set Print sequence to “By object” to avoid stringing between the parts.
  • Print standing on the bottom part with the holes, no supports needed, only outer brim recommended.
  • Dry your TPU before print.

Print with 0.4 mm Nozzle:

  • 0.08 mm Layer height
  • Only 1-2 walls 
  • 15% Gyroid infill
  • Snug fit - doesn't need glue

Experimental (not recommended as default) Print with 0.2 mm Nozzle:

  • 0.06 mm Layer height
  • Speed only 10 (Initial layer) - 20 mm/s (Other layers) + slow down for overhangs to half
  • travel speed 80 mm/s
  • Outer Brim with 0.2mm gap
  • Print sequence By object (when printing 2 pieces)
  • 3-4 Wall loops
  • 5 Top and Bottom shell layers
  • 0% infill
  • 5% up Flow ratio
  • Nozzle temperature 205 C (210 C for first layer)
  • Bed temperature 55 C (60 C for first layer)
  • Fan speed 30 - 60 %
  • Retraction speed 20 mm/s
  • Retraction length 0.8 mm
  • Z-hop 0 mm
  • Would probably need a drop of glue to stay safely attached

⚠ This setting is tested with SUNLU TPU 95A, if you use any other, some settings may need adjustment.

Tags



Model origin

The author marked this model as their own original creation.

License