Multiboard straight peg, 5,6 x 15mm

This is a more narrow Multiboard peg for mounting tools that are light, but have quite narrow built-in mounting holes (for nails or similar).

All variants:
- 5,6 x 15mm straight peg
- 5,6 x 25mm straight peg
- 5,6 x 35mm straight peg

The peg radius is 5.6mm, and length is roughly 15mm. It has also small chamfer for strengthening the peg (although I have not tested the pull strength) and small notch in the end for preventing tools from sliding off.

Printing settings:

I used PLA for printing, 15% grid infill, 3 perimeters for strength. Printing orientation is side against bed, no supports needed.

Model uses Multiboard Pegboard Click as base.