Heart domino

I hate setting up dominoes) So I created a reusable domino!

Please note, fantastic customizers for creating STL on my Patreon. 
https://www.patreon.com/c/PrintInPlace_fun
For only 5 USD you can download 4 of my programs "Amazing STL Creator" for creating different types of souvenirs, as well as several amazing STL models.

Print settings for this heart are the most common: 0.4 mm nozzle, 0.2 mm layer height, 100% infill, print speed 60 mm/s. 

After printing, rotate the plates several times. If there are parasitic threads between them, self-cleaning will occur after a few cycles of turning the plates. 

The larger the scale (120 or 150%), the more reliable it will work (the plates are heavier and printing defects are less of a hindrance). But already at this 100 % scale, the dominoes fall reliably.

Just tilt this heart and the dominoes will settle into their original positions.

In addition to the heart, you can download the STL "diamond domino" and "linear domino". But be careful, these were preliminary versions, and they may print poorly.

"linear domino" - prints quickly. But this was the very first STL, with which I started to optimize. And it needs to be held at an angle of about 30 degrees, so that the dominoes fall normally.

There are thin support plates on “diamond domino”, and they require good adhesion. It is not visible in the photos, but two of my support plates have shifted and become slightly crooked.

Please see my other designs

if you want to legally sell 3Dprints of my models, please become an active subscriber of my Patreon page:
https://www.patreon.com/PrintInPlace_fun