Bolt Sleeve traction board mount
A Sleeve (75mm) for an M8 bolt with a fatter end to hold traction boards onto the van
1
9
0
66
updated
January 17, 2025
Description
PDFI needed something that would allow quick release of the traction boards without spending a fortune on mounts.
I mounted long M8 bolts to the back of the van. I used 100mm bolts which was perfect for amazon special traction boards.
Put the traction boards on, slip this sleeve over the bolt followed by a washer & nut. I used eyelet nuts for quick access.
May add a
Printed in PETG but I Imagine PLA will be fine
V2 - Added bevel on the edge to make it easier to insert
Model origin
The author marked this model as their own original creation.