Battery Power Tap compatible with Ryobi 18v

This is based on Battery Holder for Ryobi 18V battery by Walpeup December 29, 2015
https://www.thingiverse.com/thing:1234683

However... the bottom part needed to be just a tad bit deeper so the battery (4Ah, 6Ah, 9Ah) would clip in correctly, this inadvertently created a small bump out around the perimeter, which I like, as makes it easier to grip the sides and separate from the battery, I made no changes to top part (where terminals are)

Shown with...

Anderson Powerpole connector...
https://powerwerx.com/anderson-powerpole-connectors-45amp-bonded

Keystone 209 battery contacts...
https://www.amazon.com/gp/product/B06VTPWM6M

14AWG (or larger 12AWG) silicone wire is suggested

Black hot glue to insulate and keep terminals in the ideal flat contact position...
https://www.amazon.com/gp/product/B0058TX64U

See another version of a battery power tap here…
https://www.printables.com/model/115143-battery-power-tap-slim-compatible-with-ryobi-18v

Don't have a 3D printer? Order already printed from: https://www.tindie.com/stores/jpelectron/