A wall mounted holster for a Bosch 36-4 eBike charger so I dont keep kicking it around on the floor. Holds the charger pretty securely, it's not going to fall out.
Jan-2020 : I have uploaded a new version of this; with a clip to hold the charger plug when not in use. I also slightly updated the design to tighten the fit on the 'wings'. I have uploaded models for both left and right clips, plus a 'no clip' version.
There are two 5mm mount holes (+ recess and adjustment) for mounting but my target wall is 35+yr old reinforced concrete and I didn't want to borrow my neighbours SDS drill (again), so I also put a big base on it and have stuck to the wall with carpet tape..(strong stuff). I deliberately left a big air channel behind this to assist cooling.
PS: sorry for the awful lighting in the photos, my phone camera did not cope well with very black objects on a white wall.
Printer:
K280
Rafts:
No
**Supports:**No
Resolution:
0.2
**Infill:**20%
Filament: Real Filament PLA Black
Notes:
Quite a chunky print, I do not want it to sag with age so I set infill to 20%.
Category: OrganizationThe author marked this model as their own original creation. Imported from Thingiverse.