A remix of the ttt_-_gate_a_3 and ttt_-_gate-a-2 pieces of the 80cm Stargate

Spradlinb created modifications to allow for lighting of the Stargate, but to make the wormhole, I needed to create a hole for the lighting to come out underneath the Stargate, see photo of channel in white supporting piece.  The the remix of Martin's ttt_-_gate_a_3 from his 80cm Stargate allows for the routing of the wires.  This is used in combination with Spradlinb's support for the electronics remix.  You may want to file the rough edges on the exterior of the channel so it will not damage the wires.  

I have also included remixes of ttt_-_gate_a_3 and ttt_-_gate-a-2 pieces with a ridge and slot to assist with gluing these last pieces together.  These are optional, I just found it useful for the final glue up to have this slot and ridge.

This remix creates a channel in the ttt_-_gate_a_3 for the wormhole lighting to be routed in the back of the Stargate.  And optional model remixs of ttt_-_gate_a_3 and ttt_-_gate-a-2 pieces which inclues a ridge where the two pieces can be glued together.