O4 Mobula Canopy Adapter

Remix of Krhom's first O4 mount.

No supports needed, printed in TPU 95A, works with the OEM self-tapping screws, maintains some camera tilt options. 

You do need to trim the canopy arms around the USB-C and the Digital port so they're not applying too much pressure on them. You do need to trim a small amount of the camera open for an unobstructed field of view as otherwise you can see the canopy at the very edges only at the lowest highest tilts.

UPDATE 1/15/25:
Added the step file, with adjustment so that camera is pushed forward by 1mm, which should help if you see any  canopy in your FOV

UPDATE 1/17/25:

New V2 designed to isolate the camera from the canopy to minimize jello, optimized lens positioning for unobstructed canopy view without any cutting, tabs that better secure the camera to the adapter, and a bottom wall to prevent the camera PCB from striking the VTX board in the event of a hard crash.

Added mounting support for Mobula6/7 canopies, reinforced rear clamps and does not require any supports