Flexible Zip Tie Mount

Features:

• Flexible base to mount to convex or concave rounded surfaces
• 26mm base to facilitate 1" (25.4mm) 3M VHB tape

• Height to facilitate two 5mm zip ties (vertical & horizontal) In order to get the groves on the bottom your tolerances need to be pretty tight. It will work fine without them, however it flexes a little nicer with them. I printed with PLA so it will flex once or twice. If you keep bending it back and forth it will break eventually. The bridge for the zip tie keeps the center from fully flexing, but if you push in on the middle right it will bend a bit. Also you probably need active cooling to get bridge the gap on the top. If your filament sags a bit you can clean out with tweezers or a razor knife before using.

  Print Settings

Printer Brand:

LulzBot

Printer:

Mini 2

No

Supports:

No