Siku replacement front loader / SIKU 1544 & 1540

This is a simple replacement front loader (Frontlader) for all SIKU models with a front loader like the 1544 New Holland, 1540 John Deere or the 1393 Fendt.

For gluing the pieces together I used a glue from Revell but super glue should work just as fine. The used screws are a M2 x 18mm screw and a nut to fix the tool on the front. (Can be any other tool as well) In the back I used M2 x 4mm screw to function as the small tabs holding the front loader. I used screws here because I think 3D printed tabs would break of even easier than the original once.

The M2 srews are a bit too small I think M2.5 would fit better but this is what I had laying around. If you are planning on buying screws I would recommend M2.5.

Make sure you have a good bed adhesion when printing this since it is pretty small.

I printed it in PLA and PETG both works. 
I used 100% infill and 4 Permitters.

Check out my compatible pallet fork: https://www.printables.com/model/1101299-siku-1544-new-holland-palettengabelpallet-fork