(ITX MOBO - ATX PSU) Veloroza MAX 1 Pc case v1.5

This is a culminating event of a week of modeling and lots of coffee. This monster of a PC case is equipped with 3 , 2.5inch ssd mounting points, ATX PSU support, 6; 120mm exterior fan mounts, 2.5 slot PCIe slots, and plenty of room for cable management! The power button is a 7mm normally off pushbutton that you attach to the F_panel port on the MoBo. A bed size of 256x256x256mm is needed to print all pieces with out spitting, supports are required. Was originally printed on a Bambu Lab A1. PLA , PETG, or ABS are my recommended filaments.

STATS:

• 3, 2.5 inch ssd mounting ports
• ATX PSU support
• 6, 120mm exterior fan mounting ports
• 2.5 slot PCIe slots
• full height GPU 
• ITX motherboard support

REQUIREMENTS (what your printer must have / assembly materials)

• PLA, PETG, or ABS filament
• 256x256x256mm build plate
• 11 Standard fan screws (the screws that come with fans) NOT AIO SCREWS (but you can use them wile mounting the fans 
• 8, 2x8mm magnets 
• 7mm normally open pushbutton 

More instructions to come! :)

Made the PSU holder thingy compatible with ATX PSU's instead of l-SFX, made the holes in the test bench to attach to the case, and the hole damn case it self was me.