Speedy Bee Mario 5 alternative capacitor mount.

The original capacitor mount on the Mario 5 (slung under the flight stack) does not fit a Panasonic LM and is prone to causing the capacitor leads to short out against the carbon midplate. This model will sit at the front of the drone behind the camera. You can also just double side tape mount a buzzer to the walls of the cradle. 

Changes needed:
You will need to rotate the stack 180* so the power pads on the ESC is facing forward. Make sure to properly configure everything in beta-flight before test flight. I would also recommend soldering the power leads under the ESC. Be sure to insulate with some Kapton tape to avoid shorting out against the frame. I also added the extra O-rings to give the ESC a tiny bit more height.

All the hardware that is needed to mount the capacitor cradle is already included in with the frame. Except for a tiny zip tie that is needed to secure the capacitor.

MAKE SURE TO HEAT WRAP THE LEADS OF THE CAPACITOR

Additional prints:

• Optional cover
• Optional plug for the bottom of the frame to cover up the hole where the capacitor use to sit.

Printing:

• The cradle needs no supports, print in TPU 3 walls. If screw holes are too small widen with a small screw driver.
• Plug will need supports
• Cover doesn't need supports.