DT830D stand

Snap on DT830D stand with test lead holders.

Features:

• Snap fit, locked in place by pins in the screw hole, no fasteners needed
• Designed to use minimal support (the stand is upside down, make sure to slice it correctly)
• Built in foldable stand, use a piece of 1,75mm filament as hinge
  • The base holes are 1,8mm, the stand is 2mm
• The center of mass is low on this model, so the multimeter sits flat on your desk when the stand is closed
• Leads are exposed on the bottom so you can connect alligator clips