90° Glove Clip (Individual Glove Clips)

I wanted a clip to store my cycling gloves near my helmet, but didn't like how one would be pinned against the wall by the other with current clips.  I designed a new clip that grabs the edge opposite the thumb of each glove individually so they can be stood away from the wall for better drying if they are damp.  Gloves can also be slipped under both prongs flat against the wall like most other clips hold them.

The hole is sized for a 4mm flathead screw, although I believe a #6 would also work, but I have not tested it.  The hole is not large enough for a #8 screw.  Printing this model requires supports to support the glove clip that is not sitting flat on the bed.