Lightning Blaster Pro suppressor swap mod

This mod to the Lightning Blaster Pro allows you to quickly swap suppressors and/or flash hiders. This mod involves no cutting of the blaster shell and can be accomplished in about thirty minute. If you would like to build the MFG (muzzle flash generator) version of the suppressor you will need to unsolder the original leds and solder longer wires with some sort of connector (I used an xt-60, it was way too big). The connector allows the suppressors to still have the quick swapping ability without an extra battery pack (use a resistor with the leds, I blew up and burnt a few leds by overvolting them). If you decide to build the suppressor with the integrated hop-up you will need two m2x8 screws. If anyone needs an assembly video I will try to make one, just let me know in the comments. With the flash hider the accuracy is the same as the stock gun with groupings at 20 ft. being about 12-16 in. With the rifled suppressor the groupings at 20 ft. are about 4 in. The hop-up did not work as expected and instead of increasing range it caused the gellets flight path to curve sideways  allowing you to shoot others hiding behind trees; the hop-up at 20 ft. had groupings of about 1 in. There is a provided support block, beside that no support is needed.

“He trains my hands for war, so that my arms can bend a bow of bronze. You have given me the shield of your salvation, and your right hand supported me, …” Psalm 18:34-35