Dart Holder

This is a dart holder that was designed specifically to attach to the side of the Arachnid Cricket Pro 650. It may fit other models or brands. 

It holds 3 darts with 8mm grips. It attaches to the side of the dart board with two 1/8" rivets (or screws if you'd prefer). 

This model is for the right side of the board. I just used the slicer to mirror the model to print the left side. 

Print Settings

I printed flat on its back using a 0.6mm nozzle and a 0.48 layer height (I don’t mind layer lines on functional prints) and 15% infill and each took about 1h 20m to print. No supports
 

Post-processing

The rivet holes printed a tad undersize so I used an 1/8 drill bit to enlarge them for the rivets to fit through snuggly.