Knight warrior hero figures

I made a set of 8 figures for a card game. They are heroes, warriors, necromancers, wizards, shamans something similar to that. 

Go look at the files and see if you like any characters and if you download the model you can rate the print profile and let me see how did yo use figures.

I dont recommend scaling down below 5cm because than it will not include some parts in the g-code because of the too low thickness on some parts.

I suggest the most accurate print settings you can set and slower down your print speed. I used 0.08mm layer height. 

Use 100% infill for safety if you a printing a small model.

Be carefull with removing supports because you can quickly remove a thin part of your figure away if you are not carefull.

I hope the models will be useful to at least someone.