Hadley Printed Shroud/Enclosure

I will post the STL’s when I get home. The printed part is the multicolor one and then I just used black cardstock for the rest but you can do a full printed enclosure if you want to. I printed with 2 walls 20% infill but it way stronger than it needed to be, I think you would probably be fine with around 10 or 5% infill maybe even 1 wall. For the installation since I printed the max size for my printer I had to remove the LTA because the print was too high to just slide in between the tubes and then snap on. If you don’t want to have to remove anything then measure the gap between 2 of your rods and make the print slightly shorter than that so it can just fit through and twist on. The filament I used has some shrinkage but I set my print settings to scale it up a bit so make like a 5mm high test one just to make sure the scaling works for your filament

I used the ring dimensions from the Middle Tube assembly and the snap on attachments from the mirror covers to create the shroud design.