Seven-Segment Display

Please read before printing

The objects in the 'looseconnection" folder have a 0.25 mm tolerance in between joining connectors. The objects in the “tightconnection” folder have no tolerance in between joining connectors, and will most likely need to be hammered together. This exists for people who desire a permanent connection between tiles.

When you load SegmentPeice and DotPeice into your slicer, make sure to scale them to 96% scale in all directions. If it is smaller, it will wiggle in it's slot a lot. If it's larger, it may be too difficult or even impossible to push in/take out.

SegmentPeice and DotPeice should not be rotated in the slicer to avoid quality issues. Brim should be enabled, unless you have a really good printer.

If you want to make your own model using this design:

BlankTile has no holes carved into it(Exists in both folders). If you want to make your own model using BlankTile, here is some information to use:
•SegmentPeice and DotPeice are 12 mm tall
•The holes are 4mm deep, from the top of the tile
•The tiles are 8mm tall