Stick-on Holder for Harbor Breeze Fan Remote

Just a quickie drawing to make a little stick-on holder for the light and fan controller for my kids rooms. My little one is too little to reach them when put up near the actual light switch, so this puts it down on her level, now that she's old enough to be going in and out of her room on her own.

Sticks on the wall with up to 3" long command strips.

Designed to print thin, with 0.4mm thick walls it should be exactly four walls thick throughout. Benefits from the use of smoothed adaptive layer height.

Tuned print profile available over on MakerWorld.