Tumbling Poops - the fun tower game you play with your MMU printers poop!

💩 Tumbling Poops 💩 is a fun and strategic tower game where players take turns removing sticks from the tower which has been topped with your 3D printers poop! The objective is to end the game with the smallest poop pile. Removing the sticks is a test of dexterity and strategy, as each move could make the poop fall through the tower. Recommended for 2-4 players, this game guarantees an engaging and entertaining experience!

Game Rules:

1. Players take turns rolling the die to determine which colored stick to remove.
2. Play Sticks must be removed from the top half of the tower first. If the chosen color isn’t available in the top half of the tower, players can then remove it from the lower half.
3. If the die lands on a colour and there are no more Play Sticks of that colour in the tower, then skip your turn.
4. The die includes 2 “skip turn” faces (indicated by the large X), which allows the player to skip their turn when rolled.
5. Players may touch the crown, connectors and base while removing their stick, but they cannot touch the tower itself.
6. If any poop falls during your turn (including when collecting the poop) then it gets added to your pile!
7. The game ends once all the poop pieces have tumbled through the tower, once this happens compare your poop pile sizes - smallest wins! 

Setup Details:

1. Take your 24 Play Sticks and insert them into the 3D-printed tower in any arrangement you like.
2. Place the 3D-printed poop pieces on top of the tower (If any poop falls through the tower during this process, add them back to the top of the tower until all the poop stays balanced and no more falls through.)
3. Once the poop is secure and all sticks are properly inserted, the game is ready to begin.
4. Youngest player starts first and take turns going clockwise, enjoy!

Printing Options:

• Single-Color Printer: Use four different filaments to print the individual components, and play the game with a regular die deciding which number means what!
• Multi-Material Printer: Print the die iwith your MMU for a more immersive experience, and the poop pieces to play with are pre-made during the printing process.

To play the game as picture you need to print the following:
1 x Crown
1 x Base
1 x Connector
2 x Tower
7 x Play Stick in first colour
7 x Play Stick in second colour
7 x Play Stick in third colour
7 x Play Stick in fourth colour
1 x Die (optional if you do not have an MMU)

Everything is easy to print, no supports needed. The base is the only thing which you need to print upside down but this has already been done for you in the STL.

Tip: if you cant use printer poop due to a lack of mmu or poop use other items such as marbles etc!
 

Customise:

Make Tumbling Poops your own! Examples:

• Make your own rules up! (Share them in the makes section for others to see!)
  • Examples:
    • Allow each player to insert a certain colour stick into the tower however they like for more strategic gameplay!
    • Change what happens when the die lands on X!
    • You must pull the stick you first touch
• Adjust the print: Make the tower taller, wider, make more more colours! The changes are limitless!
• Design unique pieces: Make your own components for the game or design your own “poops” to play with!

✨If you like what I make ✨

• Like, follow, comment, share, review, and post your makes
• Check out my other models! :)