Creality Ender-5 PSU Terminal (Contacts) Guard

The terminals on the PSU of an ender 5 are not covered. This fixes that.
It will not prevent short or shocks when poking around with a screenshot driver or other conductive items, but at least you won't accidentally touch them.

I tried to be inclusive; there is a 240v, 230v, 110v, "Danger!" and a blank protector. (The last one in case you want something else written on it)

Insert the top site first, then click in the bottom side.

DISCLAIMER

I am not responsible for you getting shocked; always power off and disconnect the power lead before opening up the electronics case.
Just because I do not listen to my own advice does not mean that you should not either!

(Phil Collins said it; "Just do as I say, don't do as I do." and James Hetfield as well; "You can do it your own way, if it's done just how I say")

Consider yourself sufficiently warned ;)

important note;

Although the Landy LRS-350 is a clear and obvious Mean Well clone, the parts are slightly different so this guard will NOT fit an original Mean Well.

For Mean Well LRS-350 series; see https://www.thingiverse.com/thing:4781360

My Ender-5 build so far

https://www.thingiverse.com/make:890134