Anycubic Kobra 3 Side Cable Chain for Stock Camera Mount

This model uses 22 links, 22 covers, 1 end, and 1 start.

I printed mine from PLA. Some supports are needed on the start and end. 

This chain clips into the aluminum extrusion under the printer just like the existing wire managers. Thread the camera USB cable through these and then stick it into the cable chain with everything else. The top of the chain replaces the existing camera mount. If you don't have a camera, just use a single small screw to hold it in place (and then go get the camera, it's nice). 

Good luck and happy printing!

I used these chains to make a cable chain mounted to the frame's underside and replaces the stock camera mount.