Snowboard boot overhang tool

A small tool to help setup you boot centered over the board, simply mount your bindings as normal and check toes and heel sides are even, the lines on the base are in 2mm increments.

Comes apart so and fits in your pocket or tool kit.

The Tower is held in place by the friction springs. 

Make sure when you slice to model to block seams around the spring area (see picture).

Best printed in PETG for better “springiness”.

If the springs are too hard or too soft, gently bend them to adjust the friction.

The lines can be made black with a fine permanent marker for better contrast.

I was inspired by this video
https://www.youtube.com/watch?v=JI9wHOrG2r8

But the files to print the tool shown in the video is not available to download, you can only purchase the tool via Esty, so I made my own version of it.

How to use the tools is the same as shown in the video