Hello
I made a wallmount for my Minisforum MS-01 with 3 40mm fans for additional cooling without destroying or modifying the case of the MS-01.
With this u can wallmount your MS-01 or MS-A1 on the top side, where the CPU cooler sits.
The 3 additional fans blow cooler air into the case, and thus helps to keeps temps down & it will also benfit if u have a pcie card (like me) that needs cooling too.
I cool my ssds with this mod who also dont need modification to the original case
https://www.printables.com/model/906996-ms-01-fan-cover
Printsettings
PETG/PLA
Layerhight: 0,2mm
Walls: 3
Top/Bottom layer: 4-5
Infill: Grid
On the last pic in RED u can see where u have to mount this to the wall. 4mm holes. Use whatever screws fits you.
In GREEN u can see where u need to put M4 inserts to the print.
I also made a hole for the connectors of the fans to come out. For my orientation its on the bottom side.
After that u can remove the bottom plate from the case and screw the top section of the case to my model (Front of the case towards the front of the fans), screw back the bottom plate or the mod i mentioned above. Click in the frontpanel and slide in the MS-01. Done
Dont forget to put fans in the wallholder first. :D
I use a 3-12v 3a power supply @9v for the fans (external)
I use 3x Noctua 40mm x 20mm fans
i use M4 Inserts and M4 16mm screws (wich are very snug in the holes in the top of case)
Max screwlength are 24mm
I put the STEP file in here in case u want to use maybe M3 (they will fit better i think), but than u have to narrow down the GREEN marked holes a bit for your inserts.
For cleaner look u could solder the 3 fans to 1 connector.
yeah… Step file for further modification for your need was added.
The author marked this model as their own original creation.