Reusable Screwable Thread Cable Tie / Bike Mount with Quick Fastener

I printed in PETG. PETG is flexible enough not to break when the cable tie is bent.

For better results it's advisable to bend the cable tie when it is warm, for example directly after the print. Later you can heating it up with a hairdryer.

There is only one length of the cable tie, bu you can trim it to the length you need.

Remember:

• TPU: When printing in TPU the nut must not be printed in TPU too. A TPU nut is to flexible. The best results you get with the scaled down nut printed in PETG or PLA.
• PLA: PLA is very brittle and can easily break. If you need to print it in PLA for reasons, you have to heat it up with a hairdryer before you carefully bend it into its resulting shape and trim it to its resulting length.