Nintendo switch game cartridge pokeball

This pokeball switch gamecard holder is not only very nice display piece but is aswell very practical! It can hold up to 12 game cartridges.

To print yourself one of these fancy pokeballs all you need is a 3d printer (obviously), White, Black and red PLA or PETG, a bit of superglue and the printfiles downbelow.

Everything is printed with a .4mm nozzle on .2 quality in prusa slicer.

The only parts that need support is the button ring, the button, Top shell and the bottom shell.

Print the parts with the most logical orientation.

Assembly:
Once you have printed everything you can start glueing the bottom shell with the bottom switchcard holder and the top shell with the top switchcard holder

Tip: Glue some weights in the bottom shell so it doesnt roll of your table

Put the button in the button ring [Dont glue this].

Now put the button assemly in the top switchcard holder Make sure the 2 prongs on the button is facing away from the top switchcard holder

Once you've made sure that the bottom assembly and top assembly can close fine and will lock into place glue the button ring to the top switchcard holder

And finally you can push in the hinge pin to lock the bottom assembly and top assembly together

Credit to MR MrFozzie on thingiverse for designing the latching mechanism and outershell