Starliink Gebn3 cable junction cover adjusted to locally available junction.

Wider inside, tighter nut holes, shifted position of the Starlink cable to match junction used.
0
1
0
22
updated January 6, 2025

Description

PDF

I printed my one using white ASA material using .3 mm layers in draft mode. If you care about precision and less visible lines, surely it is possible to print using more precise settings.

Printing time in my case was over 3 hours.

Model origin

The author remixed this model.

Differences of the remix compared to the original

Necessary adjustment made to fit and match junction connector available locally.

  1. All cover made little shorter, it is not needed to be very long.
  2. Space inside made slightly wider. Connector bought did not fit inside original design.
  3. Most important - position of the Starlink cable is now shifted to match connector used, otherwise even if the box had more space, it was impossible to assemble everything together.
  4. Nuts are now fitting tightly enough not to fall out during mounting.

My cover is mounted using two-side tape, no need to make any holes for mounting screws. In case you may need them, it could be enough to use just two M3 screws and use two remaining holes for wood screws holding this to the wall.

License