Cleaning cloth hook for LEIFHEIT Clean Twist Disc mop handle

To have a dustcloth handy during cleaning, I created this hook for the LEIFHEIT Clean Twist Disc mop system. It can be used with any other broom stick with a diameter of 24/25 mm.

The Cloth_Holder has a hole where a cloth can be pushed through as well as the hook to store cloths or other cleaning articles.

I printed two versions, one out of TPU and one out of ASA to have it be as resistant as possible to most cleaning agents. Other materials should be fine as well. 

For assembly insert the two heated inserts into the Cloth_Holder. Then screw the Cloth_Holder into the Brace_Front with the M3X10 BHSC. Then insert the M3 nuts into the Brace_Back and screw the two braces around the broom stick to each other.

BOM:

2X M3X10 BHSC (for mounting the cloth holder to the front brace)
2X M3X12 BHSC (for screwing the front/back brace together)
2X M3 nut (for screwing the front/back brace together)
2X M3X4.6X5 (other M3 heat inserts should work as well, as long as they are not longer than 5mm) heat inserts

Print settings:

Material: TPU/PETG/ABS/ASA
Layer Height: 0.2mm
Walls: 4
Infill: Grid, 25% / For TPU use 15% Gyroid