PRUSA Accelerometer Storage Box MK3.5/S

The inlays have been adjusted to fit the holder I designed for the MK3.5/S.
The raised area where the sticker is placed has been recessed at the bottom to provide some space for the connector on the accelerometer pcb.
For the upper section, there is also a clip-on cable holder to store the cable that is normally installed in the Buddy case (MK4S).

For those wondering: On the MK3.5/S, the port where the accelerometer will be connected is already occupied. The connector from the MK3.5/S wiring harness will be temporarily removed to connect the accelerometer for calibration.

There's even a gasket for the housing! 😉

Link to MK3/S Accelerometer holder.

Happy printing!

Changed the inlays to fit the MK3.5/S version of the accelerometer mount.