Ender 5 S1 Part Cooling Duct for Revo Nozzle

I spaced the Nozzles of the fan duct and the CR touch mount down about 8.5mm to accommodate The revo nozzle and sprite adapter( https://e3d-online.com/products/revo-creality-sprite-adaptor?variant=41549424853051 ) You will need to cut off the thermister plug and heater plug from the stock heat block and solder onto the Revo heater. Besides that, everything else is bolt on. I belive I use 16mm or 14mm long screws to attach the duct and CR touch. You will need to recalibrate your Z offset and run a new PID calibrate after completing this mod. 

I recommend printing in ABS or ASA. I printed with 4 walls, 5 top layers, 5 bottom layers, and 30% infill. I printed as it is oriented using tree supports on the build plate only. 

This is a remix of Pugwash's Linear rail mod, it has the x axis switch pusher in the correct spot  and I am not sure if it will fit a stock Ender 5 S1 or not. 

modified to put the ducts of the fan and the CRTouch at the correct elevation to accommodate the Revo nozzle