Ender 5 S1 Part Cooling Duct for Revo Nozzle

stretched to accommodate a revo Nozzle and the Revo sprite adaptor.
0
2
0
60
updated January 5, 2025

Description

PDF

I spaced the Nozzles of the fan duct and the CR touch mount down about 8.5mm to accommodate The revo nozzle and sprite adapter( https://e3d-online.com/products/revo-creality-sprite-adaptor?variant=41549424853051 ) You will need to cut off the thermister plug and heater plug from the stock heat block and solder onto the Revo heater. Besides that, everything else is bolt on. I belive I use 16mm or 14mm long screws to attach the duct and CR touch. You will need to recalibrate your Z offset and run a new PID calibrate after completing this mod. 

I recommend printing in ABS or ASA. I printed with 4 walls, 5 top layers, 5 bottom layers, and 30% infill. I printed as it is oriented using tree supports on the build plate only. 

This is a remix of Pugwash's Linear rail mod, it has the x axis switch pusher in the correct spot  and I am not sure if it will fit a stock Ender 5 S1 or not. 

Tags



Model origin

The author remixed this model.

Differences of the remix compared to the original

modified to put the ducts of the fan and the CRTouch at the correct elevation to accommodate the Revo nozzle

 

License