Daemon Slayer - Inosuke HueForge

Inosuke HueForge designed by ColorMatch, so that, it's using 7 colours.

If you're using AMS, I've setup the profile with a pause to replace:

• Black → Brown
• Blue → Beige
• Green → Red

keeping White. This way, take advantage of the pause to replace the 3 colours described in your AMS.

If you opt for No AMS, you can just remove the pause or ignore it.

-----
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 114.37x200mm in size
You may print at higher layer heights below the Min Depth of 0.32mm

Filaments Used:
    PLA BambuLab Basic Black Transmission Distance: 0.6
    PLA BambuLab Matte Marine Blue Transmission Distance: 2
    PLA BambuLab Basic Green Transmission Distance: 2
    PLA BambuLab Basic Jade White Transmission Distance: 5
    PLA BambuLab Basic Brown Transmission Distance: 2
    PLA BambuLab Basic Beige Transmission Distance: 8
    PLA BambuLab Basic Red Transmission Distance: 4
This print uses 7 unique filaments

Swap Instructions:
    Start with Black
    At layer #4 (0.4mm) swap to Marine Blue
    At layer #7 (0.64mm) swap to Green
    At layer #9 (0.8mm) swap to Jade White
    At layer #11 (0.96mm) swap to Marine Blue
    At layer #13 (1.12mm) swap to Jade White
    At layer #15 (1.28mm) swap to Brown
    At layer #18 (1.52mm) swap to Beige
    At layer #28 (2.32mm) swap to Jade White
    At layer #30 (2.48mm) swap to Red
    At layer #33 (2.72mm) swap to Jade White for the rest.
 

If you resize the model make sure you do NOT scale the Z axis

---

Please leave a rating or comment if you like the print!

Want to sell my prints? Commercial License is available here: https://patreon.com/asniaire

You can check out the rest of my designs here: https://www.printables.com/@asniaire_1422755

If you'd like to support my work, you can buy me a coffee :)