CapSnap: Scalable Cap Holder for Wallmount

Printed in PLA+

Infill: 20 % (3D pattern)

Walls: 3

Printed with tree supports

Suitable diameter* of round bar: 17 mm

I will also provide later, more diameters like: 19 mm, 21 mm, 24 mm

You need for Wallmounting the additional equipment.

There are three print-models included

1.) CapSnap for Top-mounting

2.) CapSnap for the middle area

3.) CapSnap for Bottom-mounting (with a sep. hole on the back for fix the round bar)

Installation

1. First mount the round bar with the mounting parts at the wall.
2. Then add the middle parts, best gap between each CapSnap on my side: 10mm
3. Align the middle piece correctly with a 90 degree angle-tool.
4. Make a mark on the roundbar, and drill a small hole for the screw
5. Fix the middle part with a screwdriver
6. done!

Use the original and modify this, to mount the hooks on a round bar. With this, you just need to drill 4 holes into the wall to store multiple caps :)

Thanks to ohrenstoepsel for his model!